Aura fotók
AURA foto

Guide for assembling the appliance

Parts of the appliance

1. Transmitter head
2. Information container
3. Connecting cable (to link transmitter head to information container)
4. Vertical shaft
5. Base mounting screw
6. Head mounting screw
7. Base

The complete set contains:

1. A carrying case
2. A complete VST appliance
3. An instruction manual

      Using the right combination (code) numbers supplied, unlock and open the carrying case and check the parts against the list above. Start by assembling the stand: first take out the base. Insert the screw into the hole and twist it into the vertical shaft carefully so that the thread doesn't get damaged. After that tighten the screw. Then loosen the head mounting screw and push the peg in fully into the hole underneath, and set the transmitter head in the right direction. The next step is connecting the information container to the end of the transmitter head with the connecting cable supplied. Find the two holes and plug in the two ends of the connecting cable. Having completed these steps the appliance is ready for use.  When not in use please keep the appliance in the carrying case or set the appliance so that the tip of the transmitter head touches the copper tip of the information container.

Using the appliance

1. Please keep to the treatment programme enclosed
2. Duration of treatment is between 30-60 minutes for general conditioning.
3. In the case of injuries direct the transmitter head at the affected area to kill the pain.